Audio Note TT-2 Deluxe, TT-3, TT-3 Reference, IO Gold, S8 Stepup

 

 

 

Audio Note TT3 Turntable

 

 

 

TT-3 Half Reference Turntable (new Product)

 

 

 

 


 

 

The AN-S4 is a passive device, designed to convert the mainly current output of your Moving Coil cartridge (MC) to a higher voltage, low current signal of sufficient strength to allow a Moving Magnet (MM) phonostage to amplify it to a suitable level.

The internal transformers used in the AN-S4 are manufactured by Audio Note (UK) exclusively. Each transformer is made from 0.1mm laminated super mumetal 250 and wound with 99.99% pure Silver wire. Each Transformer is then housed in a mumetal screening canister to minimize noise and interference.

The AN-S4 can be supplied in a variety of versions, as listed in the table below: -

AN-S4L 3 Ohm input impedance
For cartridges with an internal impedance of 1 Ohm, primarily designed for use with the Audio Note (UK) IO range

AN-S4LM 4 Ohm input impedance
For cartridges with an internal impedance of 1 to 2 Ohms

AN-S4ML 9 Ohm input impedance
For cartridges with an internal impedance of 2 to 4 Ohms

AN-S4M 16 Ohm input impedance
For cartridges with an internal impedance of 4 to 6 Ohms

AN-S4MH 36 Ohm input impedance
For cartridges with an internal impedance of 9 to 12 Ohms

AN-S4H 64 Ohm input impedance
For cartridges with an internal impedance of 16 to 21 Ohms

 

 

 

Audio Note Io Gold Cartridge

The Io range of cartridges from Audio Note UK are world-renowned for their stunning quality and their effortless ability to reproduce music to the highest standards. The revolutionary nature of the Io design runs contrary to most accepted design criteria, but the result is a small range of hand-made moving coil cartridges that are second to none in terms of dynamic range, tonal balance, separation, timbral reproduction, and lack of colouration and surface noise. The cartridge designs do not lend themselves to mass production and as a result are extremely time-consuming to produce. They require a tone arm of very substantial torsional rigidity, and must be combined with a matching step-up transformer in order to achieve the best possible linearity and dynamic signal transfer.

All Io cartridges are hand-built in the UK to exacting standards and feature ALNICO high-density magnets, silver-wound generator coils and a titanium cantilever with an Audio Note AN Type-1 profile, diamond stylus. The Audio Note Io Gold has generator coils wound on a Permadure-iron former and is supplied with gold-plated gun-metal sides. The highest possible tolerances are used when selecting the cantilever, stylus and generator.

Please note that due to the hand-made nature of Io cartridges, they are often not available from stock.

SPECIFICATIONS:

Output voltage: 0.05mV
Coil impedance: 1 ohm
Matching impedance: 3-4 ohms
Frequency range: 10Hz-50kHz ± 3dB (dynamic test)
Channel separation: greater than 25dB at 1kHz
Compliance: vertical 15, horizontal 10
Stylus tracking weight: 1.5-3.5 gm
Weight: 20 gm

 

 

 

Notes: Audio Note (UK) Ltd. reserve the right to change, modify, add to, or remove any of the content (was originated from website www.audionote.co.uk) at any time without prior notice. Further, images on this site may differ from current models or specifications.